USB DSO: The Enclosure
Posted Tue, 10th Apr '12 at 4:34am by Blackthorne TA
Given my DIY nature as seen in the development of this project so far, you should be able to guess that I would design and fabricate the enclosure myself as well. 
I decided to build it in two parts from sheet aluminum, bending the sides with a box brake.
Here is the design of the two halves:
The right side is the bottom half and the left is the top.
Here are some pics of the PCB in the bottom half of the fabricated enclosure.
From above:
From the USB side:
From the input side:
I decided to build it in two parts from sheet aluminum, bending the sides with a box brake.
Here is the design of the two halves:
The right side is the bottom half and the left is the top.
Here are some pics of the PCB in the bottom half of the fabricated enclosure.
From above:
From the USB side:
From the input side:
Total Comments 0
